![]() No all lights off and Low Power mode on or off: 160 mA.With default scale lights and Low Power mode on : 180 mA.With default scale lights and Low Power mode off (normal power): 190 mA.Here's how much current LinnStrument 128 draws: With all lights on in white, Low Power mode off: 360 mA.No all lights off and Low Power mode on or off: 190 mA.With default scale lights and Low Power mode on : 220 mA.With default scale lights and Low Power mode off (normal power): 260 mA.Here's how much current LinnStrument draws: By default, the right foot switch (or a single foot switch) is assigned to Sustain Pedal and the left foot switch is assigned to Arpeggiator On/Off. You can use either Normally Open or Normally Closed foot switches because the unpressed state is automatically sensed when power is connected. If using a single foot switch, only the Right Foot Switch setting is used. ![]() Functions of foot switches are assigned in GLOBAL SETTINGS. Stereo 1/4 inch jack for single or dual momentary (not latching) foot switch (not expression pedal). See near the end of this page for more info. This will act as a strain relief, a trick that guitarists have used for years. Tip: To protect the USB jack against damage from cable pulls, tie the USB cable around the nearest guitar strap button. LinnStrument can also be powered with any iPad with USB-C, or with an iPad or iPhone with lightning connector, though see below for power limitations from Lightning. Can be used for power with any standard USB power adaptor when using the MIDI jacks. Use for 3.7 times faster MIDI speed than the MIDI jacks, and to provide power. There's little need to connect MIDI IN unless you're using MIDI Sync or want custom MIDI control of the panel lights. Be sure MIDI I/O (in Global Settings) is set to MIDI JACKS. Standard full-size MIDI IN and OUT jacks. Or any AC supply with 9 to 15 volts, at least 300+ mA, can also be used. Any DC power supply, center negative or center positive from 7.5 to 15 volts, at least 300 mA can be used. (Not on LinnStrument 128): Standard round power connector, for use when not getting power from USB.
0 Comments
Leave a Reply. |